• Follow us
Home > News > Content
Mud Pump Avoid Frequent To Pump
Oct 20, 2017

Mud Pump Avoid frequent to pump

Mud pump use and maintenance Notes 1, open pump before the pump and pump in the process, to effectively inhibit the mud pump vaporization, in order to avoid frequent to the pump phenomenon occurs when using the mud pump to transport high temperature liquid , In the start before the need to do a good job of the warm pump work, to prohibit the emergency start in the cold mud pump 2, the use of F1300 / 1600 drill through the drilling pump is used in rolling bearings, rolling bearings are precision mechanical parts, Service and load characteristics of high, must be carefully on the rolling bearing maintenance, in the installation before the bearing from the box open to take out, always have to prevent dust and foreign matter into the bearings, bearings must be cleaned, remove the packaging with anti-rust grease, should use clean Kerosene or other solvents. 3, after stopping the pump in the oil drilling, the mud pump for a long time kerosene for operation, the type of gear so that the pump shaft in one direction force, resulting in shaft bending, so the mud pump to the regular detection, to the same direction The shaft rotation 120 degrees, to avoid the impact of the shaft bending mud pump 4, disassembly and maintenance mud pump in the oil drilling operations put into use before the construction workers must understand and familiar with the structure of the mud pump, assembly sequence and methods, the use of procedures, To ensure that the mud pump in the use of the normal operation of the mud, mud pump the various components to be timely cleaning and dredging, wear parts to be timely replacement, so as not to delay the normal use of the mud pump, the mud pump to regular testing and Maintenance, to provide mud pump work efficiency and quality. Mud pump is an important equipment for mud circulation system in oil drilling. Due to the high sediment concentration, high pressure and large viscosity, So pay attention to strengthen the daily maintenance of the mud pump to extend the mud pump in the oil drilling life. Mud pump in the oil drilling work principle: mud pump is a longitudinal drilling and conveying mud piston reciprocating pump, with the general working principle of the reciprocating pump is basically the same. The mud pump is composed of two parts: the hydraulic end and the power end. The hydraulic end is composed of a pump cylinder, a piston, a suction valve, a suction pipe and a discharge pipe and a discharge pipe. The power end is composed of eccentric wheels, Rod and so on. In the oil drilling operation, the mud with the drilling of the drill into the underground mud pump is the basic function. The mud pump also has the function of cooling the drill bit, cleaning the drilling tool, driving the drilling and so on, and can bring the diamond lith ground to the ground. In the process of oil drilling, the circular drilling is usually used. The mud pump can send the surface rinse medium such as water, mud or rinse liquid directly to the bottom of the drill through the faucet, high pressure hose and the center hole of the drill pipe column under certain pressure , To play its cooling bit, drive drilling, the gravel cans back to the ground role. In the oil drilling operations commonly used in the mud pump generally have a piston and piston type, driven by the engine crankshaft crankshaft rotation, and then driven by the crankshaft plunger and piston in the mud pump pump cylinder reciprocating motion, to achieve pressure and The purpose of the cycle rinse.